|
News & Info
|
 |
 |
Seller Signup...
Quality Service, Seller or Tradesperson? Sign Up Now!
|
|
Home & Garden Articles
The Right Way To Shock Your Swimming Pool
Mon 15 Jan 2007 - 11:13
The Right Way To Shock Your Swimming Pool
By Matthew Gio
There are so many different kinds of shock on the market including
-Calcium Hypo ( the active ingredient )
-Lithium
-Non-Chlorine
-BaquaShock
and More
These are the 4 basic ones out there. If you have a vinyl liner above ground pool or in ground pool and you are using chlorine then you are probably using calcium or lithium shock. The difference between the two is that calcium you have to pre-dissolve for liners and lithium you do not. Non-Chlorine shock you probably use if you are using bromine or some other sanitizer for your pool. And your using baquashock if you are using baquacil as your main sanitizer.
How To shock your Pool Using Calcium Hypo
If you are using a vinyl liner pool then you must predissolve each bag of shock in its own bucket of water. This stops the shock from laying on your liner and bleaching it.
Note: Always Use Gloves
Take one 1lb bag of shock and pour it into a warm or cold 5 gallon bucket of water about 3/4 full.
Note: Always add shock to water not water to shock. Wear clothes you
don't care about cause they might get bleached. Warm water dissolves
shock faster than cold, its your choice.
Use a wooden stick and stir around the shock making sure it gets all dissolved or as much as your can. Pour the bucket of shock all around your pool or heave some in the middle. You may have some undissolved shock at the bottom of your bucket. In this case just dip your bucket in some pool water give it a swish around and pour it back into the pool to help dissolve some of that shock.
If you have a bigger pool or a problem and you need to add more bags of shock repeat this procedure for as many bags as need. DO NOT mix all the bags together in one bucket.
Tip: Always Shock At Dusk or Nighttime. This allows the shock to reach
breakpoint oxidation. If it were during the day the sun would burn off
1ppm of shock every hour causing it only to reach breakpoint for an
hour instead of 8-10 hours.
Note: most shocks require at least 8 hours with no one in the pool read
the label before adding shock. Also some dealers will tell you to add
shock directly to your skimmer. This is not a good idea especially if
you have chlorine or an automatic chlorinator. Reason being is because
calcium hypo and tri-chlor, which can be found in chlorine tablets,
creates a harmful chlorine gas. To get to the point, your automatic
chlorinator could explode. It's happened.
Shock should also be added every week to ensure a clean and green free pool.
How to shock a pool with lithium or non-chlorine shock
This one is easy. Just sprinkle the bag of shock all around your pool as many times as needed. These two kinds of shock do not require a pre-dissolve and do not require them to be put in at night. But they
aren't as effective at killing algae and are more expensive per bag than calcium.
How to Shock a Pool with Baquashock
Again this one is easy too. Just pool the gallon bottle into your pool. You should do this once a month but more is required if your pool test shows otherwise.
http://www.swimuniversity.com
http://www.swimu.com
Article Source: http://EzineArticles.com/?expert=Matthew_Gio
http://EzineArticles.com/?The-Right-Way-To-Shock-Your-Swimming-Pool&id=413848
Looking for information on General Home Improvement, Find a supplier at HomeWise.ie
back to General Home Improvement articles
back to all home & garden articles
|
|